Adjusting Garage Door Tension Springs

How to safely adjust your garage door spring.

Adjusting garage door tension springs.

If the door was closing too quickly move the spring to the next higher hole on the bracket. This video applies t. Open it just as wide as you can without hitting the garage door opener s stop bolt and place a clamp on the track on both sides to keep the door in. Hold the garage door in this position by attaching a c clamp to the track at a point below the lowest door roller wheel.

There are two torsion springs at each side of the garage door. Diy garage door repair and save money. If your garage door cable is at an angle or l. The springs are located at the top inside part of the garage door.

Once the spring is free of tension remove from its track hanger. You need proper tension on a garage door to operate the door by hand or with an automatic opener. This is accomplished by opening the garage door as fully as possible until it hits the stop bolt on the track. If it was opening too quickly move it to the next lower hole.

You must release the tension on the garage door springs before attempting adjustment or replacement. If the garage door isn t opening or closing properly then check the tension on the torsion springs for needed adjustments. The torsion spring helps the garage door open and close easily. How to adjust garage door tension.

This video will show you how to repair a mis aligned garage door cable. To avoid injury make sure the spring is completely free of tension before removing. Adjust the springs on both. If the tension is too loose the springs that help lift the.

With an extension spring door the goal is to take all the tension off the door before you even think about touching a spring you can do this by opening the door all the way and propping it up with a ladder. Adjusting an extension spring door.